COOLING BASEBALL CAP

---

Evaporative Cooling Clothing works under the same principle your body uses to cool itself. Your body sweats, the moisture on your body evaporates and this cools your body. The lower the humidity the greater the ability for the moisture to evaporate and provide the cooling effect.

The polymer crystals turn into gel and hold moisture. The crystals will hold the water in a way that will not make the hat feel wet to the touch after the hat is hydrated properly.

---

Our low profile cap design has a lightweight polyester six panel mesh crown that breathes and allows our exclusive bandoo to cool. We've placed our two channel, flat bandoo design where the sweatband usually is for optimum forehead cooling.

We've also included an adjustable hook and closure at the back of the cap so we'll fit just about everyone. This special cap is patented so you can only get it from us. The golfers you know will love this cap!

---

General Use Tips

• Soak hat in water for approximately 5 mins (soaking times will vary depending on local water mineral content)
• Crystals may settle to one side of the hat during shipping
• First Time Use: soak the hat for a few minutes to soften the crystals
• Massage the softened crystals evenly around the hat for further hydration
• After crystals are properly hydrated, pat the hat dry with a towel, and let the hat sit to the outer desired dryness.
• The hat is ready to wear.
• Occasional waving of the hat will increase general evaporation and the cooling effect.
• If the hat is over hydrated the crystals will continue to absorb water and press through the fabric.
• If the hat is over hydrated, wipe and wash the excess crystals off and pat dry for use.
• Over hydration will also decrease the the size of the hat making it feel too tight.

General Use Tips

• Soak hat in water for approximately 5 mins (soaking times will vary depending on local water mineral content.
• Crystals may settle to one side of the hat during shipping
• First Time Use: soak the hat for a few minutes to soften the crystals then massage them around the hat for further hydration
• After crystals are properly hydrated pat the hat dry with a towel and let the hat sit to the outer desired dryness.
• The hat is ready to wear.
• Occasional waving of the hat will increase general evaporation and the cooling effect.
• If the hat is over hydrated the crystals will continue to absorb water and press through the fabric if this happens, wipe and wash the excess crystals off and pat dry for use.
• NOTE, over-hydrating the hat will cause the crystals to expand and press through the fabric.

Reviewed 0 times

Average Rating: